Hello all,
HP Microserver Gen 7 N54L, 8GB, ZFS RaidZ1 4x 4TB WD Red. Running FreeNAS since V8. Home nas, on 24/7. and was updated from v8 to 9.x sometime in 2016.
Recently upgraded from 9.10 to 11.1 Beta 1 on 21 July. (didnt realise this was a beta.. o well . lost access to existing Jails and Plugins - late night upgrades hey!!).
Upgraded to 11.2 Beta1 on 29th July - introduction of new UI.
Upgraded to 11.2 Beta2 on 4th Aug. (yesterday)
v11 has introduced massive delays in boot times.. over 5mins from power on to prompt.
I have been cleaning up and reorganising data, moving, copying and migrating data off to external systems and disks, then deleting that data from nas.
This has been working well until 11.2 Beta 2.
Removing files and folders either via smb/cifs, or direct on nas via cmd rm/ rm -R is causing complete system lock up. - the web interface renders page not found, ssh disconnects, ping unavailable and on the direct console the host is completely unresponsive. -- A complete power cycle is required.
Is there a way to identify if the data is problematic or if beta 2 has a gremlin. ?
would booting back into env 11.1/11.2b1 work ?
Pool is healthty. 70% full. scrubs are clean. temps are good, smartd is happy.
thanks in advance.
HP Microserver Gen 7 N54L, 8GB, ZFS RaidZ1 4x 4TB WD Red. Running FreeNAS since V8. Home nas, on 24/7. and was updated from v8 to 9.x sometime in 2016.
Recently upgraded from 9.10 to 11.1 Beta 1 on 21 July. (didnt realise this was a beta.. o well . lost access to existing Jails and Plugins - late night upgrades hey!!).
Upgraded to 11.2 Beta1 on 29th July - introduction of new UI.
Upgraded to 11.2 Beta2 on 4th Aug. (yesterday)
v11 has introduced massive delays in boot times.. over 5mins from power on to prompt.
I have been cleaning up and reorganising data, moving, copying and migrating data off to external systems and disks, then deleting that data from nas.
This has been working well until 11.2 Beta 2.
Removing files and folders either via smb/cifs, or direct on nas via cmd rm/ rm -R is causing complete system lock up. - the web interface renders page not found, ssh disconnects, ping unavailable and on the direct console the host is completely unresponsive. -- A complete power cycle is required.
Is there a way to identify if the data is problematic or if beta 2 has a gremlin. ?
would booting back into env 11.1/11.2b1 work ?
Pool is healthty. 70% full. scrubs are clean. temps are good, smartd is happy.
thanks in advance.
Last edited: