Hazimil
Contributor
- Joined
- May 26, 2014
- Messages
- 172
Hi All, as per my problem mentioned in this post, which was logged as bug. Basically in FreeNAS 11.3-U1 my server kept crashing when the Jails were loaded (via load config), finally, I managed to quickly stop the Jails before it crashed and disabled auto-start; this stopped my server from crashing.
The response I had from IX Systems was:
Unfortunately networking is one area in which I am weak, however the sever has been running for 3-years now with the two network ports active on the separate IP numbers, it's only now with v11.3 that I seem to have a problem. My network ports are assigned the following IP numbers by my router:
192.168.0.100/24
192.168.0.101/24
192.168.0.102 (this is the BMC port)
Happy to accept its network, as this is what I was expecting it to be as it was linked to the Jails starting up and most probably allocating IP/mac address (which I understand the process has has changed in v11.3). However, I'm not sure what IX means by "two network interfaces with IP addresses from the same segment" nor what "LACP aggregation" is, can you point me to any resources to assist with this?
Finally, before I bring up my Jails, would it be useful for me to edit them and "update if necessary" the networking aspects of the Jail configuration?
Any help would be appreciated as at the moment I have no Jails running :(
EDIT: I see there are a couple of pinned threads about this in this forum, but it's all a bit confusing me - might have to read it a few times to figure it out, but any pointers welcomed.
Thanks,
Jonathan
The response I had from IX Systems was:
It is difficult to diagnose without seeing state of the problem. I haven't tried to load your config onto real system. But it looks wrong even with jails disables to see two network interfaces with IP addresses from the same segment. You should either disconnect one of them, or, if you really want to use both – configure LACP aggregation on both switch and FreeNAS. Depending how your jails are configured, I suspect you may create some network loop. Please clean up your network config and then les us know if the problem still exist and respective details.
Unfortunately networking is one area in which I am weak, however the sever has been running for 3-years now with the two network ports active on the separate IP numbers, it's only now with v11.3 that I seem to have a problem. My network ports are assigned the following IP numbers by my router:
192.168.0.100/24
192.168.0.101/24
192.168.0.102 (this is the BMC port)
Happy to accept its network, as this is what I was expecting it to be as it was linked to the Jails starting up and most probably allocating IP/mac address (which I understand the process has has changed in v11.3). However, I'm not sure what IX means by "two network interfaces with IP addresses from the same segment" nor what "LACP aggregation" is, can you point me to any resources to assist with this?
Finally, before I bring up my Jails, would it be useful for me to edit them and "update if necessary" the networking aspects of the Jail configuration?
Any help would be appreciated as at the moment I have no Jails running :(
EDIT: I see there are a couple of pinned threads about this in this forum, but it's all a bit confusing me - might have to read it a few times to figure it out, but any pointers welcomed.
Thanks,
Jonathan
Last edited: