Thanks for everyones help.
I have a FreeNAS setup (FreeBSD 8.2-RELEASE-p1, FreeNAS Build: FreeNAS-8.0-RELEASE-i386) and have been using it successfully for about a year. Then the power went out. I restarted the server. Now I can't access the server files on my MAIN computer (wired through my router). All the other computers in my house can access it, wired directly and wifi. I can even access the Freenas firmware from my main computer. The server shows up in my router firmware as an attached device. I rebooted the server,checked my shares, checked all the settings I could think of. Tried to map the drives on the server directly, no luck. I am using Windows 7 sp1. Any help would be appreciated. I am relatively new to Freenas and networking (although I did muddle through the initial setup)Thanks for all your help!
Main System:
i7 2600k
Asrock P67 extreme 4
4GB DDR3-1600
Router: Netgear WNDR4500
Server System:
AMD Sempron 140 Processor
MSI 760GM-P33
4GB DDR3-1600
tek2425
I have a FreeNAS setup (FreeBSD 8.2-RELEASE-p1, FreeNAS Build: FreeNAS-8.0-RELEASE-i386) and have been using it successfully for about a year. Then the power went out. I restarted the server. Now I can't access the server files on my MAIN computer (wired through my router). All the other computers in my house can access it, wired directly and wifi. I can even access the Freenas firmware from my main computer. The server shows up in my router firmware as an attached device. I rebooted the server,checked my shares, checked all the settings I could think of. Tried to map the drives on the server directly, no luck. I am using Windows 7 sp1. Any help would be appreciated. I am relatively new to Freenas and networking (although I did muddle through the initial setup)Thanks for all your help!
Main System:
i7 2600k
Asrock P67 extreme 4
4GB DDR3-1600
Router: Netgear WNDR4500
Server System:
AMD Sempron 140 Processor
MSI 760GM-P33
4GB DDR3-1600
tek2425