FlexibleToast
Dabbler
- Joined
- Aug 10, 2014
- Messages
- 32
I downloaded FreeNAS 9.3, did a sha256 check. Then I used the dd command with bs=64k to create my install media. I've tried two different USB drives, port on the front of my case, port on the back of the motherboard. I Google'd the error and it looks like it is related to not supporting USB3. In the FreeNAS 9.3 docs I found this:
"when using a USB stick, USB 3.0 support is disabled by default as it currently is not compatible with some hardware, including Haswell (Lynx point) chipsets. If you receive a “failed with error 19” message when trying to boot FreeNAS®, make sure that xHCI/USB3 is disabled in the system BIOS. While this will downclock the USB ports to 2.0, the bootup and shutdown times will not be significantly different."
So, I did this. I went into my BIOS and found the xHCI option and set it to disabled. I'm still getting the same "failed with error 19" message. Not sure what I can do next.
"when using a USB stick, USB 3.0 support is disabled by default as it currently is not compatible with some hardware, including Haswell (Lynx point) chipsets. If you receive a “failed with error 19” message when trying to boot FreeNAS®, make sure that xHCI/USB3 is disabled in the system BIOS. While this will downclock the USB ports to 2.0, the bootup and shutdown times will not be significantly different."
So, I did this. I went into my BIOS and found the xHCI option and set it to disabled. I'm still getting the same "failed with error 19" message. Not sure what I can do next.