Obi-Wan
Dabbler
- Joined
- Dec 28, 2018
- Messages
- 17
Hi!
I have my FreeNAS system up and running and I'm working on setting it up properly. When I tried moving some files from one dataset to another today, some of the files were suddenly 0KB in size, making them useless.
They weren't critical files in any way, but this raised a few flags. Did I do something wrong? Is there something wrong with my system?
This is what I did today, but I noticed afterwards that some of the files now have size zero.
Have I done something obviously wrong here? Should I not move files this way?
Also, if relevant:
I'm still new to FreeNAS so I appreciate any and all insights!
Edit1: Adding my hardware specs
Motherboard: Supermicro X11SSM-F
CPU: Intel Pentium G4560
Memory: Samsung DDR4-2400 16 GB ECC
PSU: Corsair RM650X v2
Case: Fractal Design Node 804
System disk: Crucial BX500 120 GB
Current storage disks: 2x WD Red 4 TB (mirrored)
I have my FreeNAS system up and running and I'm working on setting it up properly. When I tried moving some files from one dataset to another today, some of the files were suddenly 0KB in size, making them useless.
They weren't critical files in any way, but this raised a few flags. Did I do something wrong? Is there something wrong with my system?
- I have is a single pool with two datasets, A and B.
- Each dataset is shared through an SMB share.
- From my Windows computer I can access the shares by writing \\ip.of.my.nas in the address bar of Explorer.
- The two shares then show up as two folders
- I can then open share A, cut some files from there, and open share B and paste them there.
This is what I did today, but I noticed afterwards that some of the files now have size zero.
Have I done something obviously wrong here? Should I not move files this way?
Also, if relevant:
- I ran memtest for several days before I started using the system
- All SMART tests indicate everything is fine
- The files are listed as 0KB in the FreeNAS shell, not just in Windows Explorer
- This specific Windows computer that I used is connected to the network using wi-fi
I'm still new to FreeNAS so I appreciate any and all insights!
Edit1: Adding my hardware specs
Motherboard: Supermicro X11SSM-F
CPU: Intel Pentium G4560
Memory: Samsung DDR4-2400 16 GB ECC
PSU: Corsair RM650X v2
Case: Fractal Design Node 804
System disk: Crucial BX500 120 GB
Current storage disks: 2x WD Red 4 TB (mirrored)
Last edited: