Anon_the_Nine
Dabbler
- Joined
- May 24, 2019
- Messages
- 10
Hey i'm very new to Freenas i built my systems only few days ago. I have been transferring data from my PC to my NAS and only get about 40MBps writes. I was hoping if someone can help me find out what is wrong with my config as i'm fairly certain i should be seeing higher write speeds. I have run the ipconfig command and the "1000baseT <full-duplex>" has been detected. Could it be an issue with my cables?
I am also suspect that the read speeds are also having the same issue however i can't fully identify for certain as i don't know how to test the read speeds.
Thanks in advanced
CPU: Intel Xeon E3-1230v6
Motherboard: Supermicro X11SSL-F
RAM: 16GB Crucial memory
4 x 4tb Seagate iron wolf in raidz2
1 x Crucial MX500 boot drive
I am also suspect that the read speeds are also having the same issue however i can't fully identify for certain as i don't know how to test the read speeds.
Thanks in advanced
CPU: Intel Xeon E3-1230v6
Motherboard: Supermicro X11SSL-F
RAM: 16GB Crucial memory
4 x 4tb Seagate iron wolf in raidz2
1 x Crucial MX500 boot drive