Hi there,
so I have this Hp NL54 microserver with 16GB ECC RAM which was running wonderfully until one day I got home from work and it was dead.
Dead as if I hook it up to a screen, it boots fine past the BIOS but when it comes to booting the OS it gets stuck at a blinking cursor.
About 1 week before this problem cropped up, I had exchanged both USB sticks I was booting off with new and bigger ones as they were quite old and only 8GB (the new ones have 32GB)
I guess I can plug in the old ones and see if it boots but how does one normally debug this?
Fresh install, import config?
so I have this Hp NL54 microserver with 16GB ECC RAM which was running wonderfully until one day I got home from work and it was dead.
Dead as if I hook it up to a screen, it boots fine past the BIOS but when it comes to booting the OS it gets stuck at a blinking cursor.
About 1 week before this problem cropped up, I had exchanged both USB sticks I was booting off with new and bigger ones as they were quite old and only 8GB (the new ones have 32GB)
I guess I can plug in the old ones and see if it boots but how does one normally debug this?
Fresh install, import config?