Hello all,
First of all, please excuse me for my english, it's not my native language.
I currently have 2 zpools in my NAS, zpool.2 is empty, zpool.1 is 89% filled. Of course, freenas is warning me of this situation.
I'm trying to transfer files from zpool.1 to zpool.2 with rsync, to free up some space, but after about 20 seconds of transfer, the motherboard (i think) starts to beep ... The sound is like a firing alarm : two tones, pretty fast, and stops almost immediately when i cancel the transfer.
First of all, here are my system specs :
I also don't know which error information to post, is there any command i should run ?
Thanks by advance for helping me with this problem.
First of all, please excuse me for my english, it's not my native language.
I currently have 2 zpools in my NAS, zpool.2 is empty, zpool.1 is 89% filled. Of course, freenas is warning me of this situation.
I'm trying to transfer files from zpool.1 to zpool.2 with rsync, to free up some space, but after about 20 seconds of transfer, the motherboard (i think) starts to beep ... The sound is like a firing alarm : two tones, pretty fast, and stops almost immediately when i cancel the transfer.
First of all, here are my system specs :
- FreeNAS-9.3-STABLE-201602031011
- Case : Norco RPC 4224
- MB : SUPERMICRO X10SL7-F-O
- CPU : Pentium G3240
- RAM : 2x8GO Crucial DDR3 ECC (I know 16Go is probably not enough and i plan to correct that)
- HDD : 2 zpools of 8x4TB drives
- HBA : IBM M1015 controller flashed in IT mode with v20 firmware
- The mother board SAS controller is also flashed with IT v20 firmware
I also don't know which error information to post, is there any command i should run ?
Thanks by advance for helping me with this problem.