Douglas Thompson
Cadet
- Joined
- Sep 9, 2014
- Messages
- 2
I have seen similar threads but nothing specific to a non-VM build. I purchased my IBM M1015 card, crossflashed it to IT-mode on a generic DELL system (Side note: The card was recognized in this system when erasing the firmware but had to be moved to a generic DELL system in order to write the firmware because of the "Failed to initialize PAL" problem). I then added it to my FreeNAS unit (specs below) and loaded FreeNAS for the first time (ever). I started with the "bleeding edge" 10.0 but re-installed 9.2.1.7 after encountering this problem. I installed the FreeNAS software to a Corsair 120GB SSD and have 3 Seagate 4TB Hybrid drives connected to the IBM M1015. The software installs fine but no drives are found on the M1015. I have switched PCI-E slots thinking that they may be spec'd differently (two blue ones for VGA and two black ones for other cards). Can anyone help me with this?
System Config:
ASUS M3A79-T Deluxe MB
AMD 9950 Phenom II Quad Core Processor
Corsair Dominator 8GB DDR2 RAM
Corsair Force GT 120GB SSD
VisionTek 5870X2 Graphics Card
System Config:
ASUS M3A79-T Deluxe MB
AMD 9950 Phenom II Quad Core Processor
Corsair Dominator 8GB DDR2 RAM
Corsair Force GT 120GB SSD
VisionTek 5870X2 Graphics Card