SOLVED i5-2500 - E3-1200 v2 Swap (Now not access to NAS)

[Mark Smith]

Hello,

Today I swapped a i5-2500 for a E3-1220 v2.

First when I booted my NAS back up I got a few error screens, and it would not progress to screen:

***
'You may try use the following URLs to access the web user interface:'

'htp://192.168.0.%%%'

'Enter an option from 1-14:'
***

However after 2 restarts it did progress to this screen, is this becuase of some set-up required with the new hardware?

Now I can't access the NAS from my PC at the IP address, I only have this set-up for the top Network port on the NAS. I have tried both just incase.

Any suggestions as to how I troubleshoot this? I am not sure if the hardware change has anything to do with this...

Thanks,

FYI:
Supermicro X9SCM
Intel E3-1220 v2 3.10GHz with Stock Cooler
10GB ECC RAM
6x WD 2TB RED
1x Noctua NF-S12A PWM
2x Noctua NF-P12 PWM
Corsiar VS350 PSU
Fractal Design Define Mini Series Micro ATX Case

 

[m0nkey_]

Swapping out the CPU shouldn't have any impact on networking if it booted okay.

Can you post the output of ifconfig?

 

[Mark Smith]

Windows 'ipconfig' from the command prompt?

 

[m0nkey_]

No, please run ifconfig on the FreeNAS box itself.

 

[Mark Smith]

Ok, how do I do this? I preume it is one of the 1-14 options?

 

[m0nkey_]

The relevant documentation for the shell is here.

 

[Mark Smith]

 

[m0nkey_]

You've plugged the ethernet cable into the wrong port. Device em0 shows you have an IP address of 192.168.0.201, but if you look below you'll see status: no carrier. If you look at em1, you'll see it has status: active.

Plug the ethernet cable into the other ethernet port and reboot. You should then be able to access the web UI.

 

[Mark Smith]

Thanks for the help its up and running now.

I had tried the other network port however without the reboot. That must of been what I missed.

Thanks Again.

 

[m0nkey_]

Excellent sir! Glad to know it's now working :)