vladimirb0b
Cadet
- Joined
- Sep 22, 2016
- Messages
- 5
I am trying to upgrade from 9.2.1.8 to 9.10.1. I have two computers that are the same, and one seems to have upgraded without a problem (in the first day at least).
The other computer keeps losing accessibility to the GUI although it responds to pings.
Here is what I have done, after a direct upgrade bricked the GUI.
1)Fresh install, initial settings done, no volumes seen, reboot, GUI comes up fine
2)Then import volumes, volumes seen, reboot, and can't connect http or browse via network
output says: "getty repeating too quickly on port /dev/ttyv0 sleeping 30 secs"
3)Reflashed iso to USB stick and "upgrade" install = still no GUI
Going back to 9.2.1.8 old usb stick works.
The other computer keeps losing accessibility to the GUI although it responds to pings.
Here is what I have done, after a direct upgrade bricked the GUI.
1)Fresh install, initial settings done, no volumes seen, reboot, GUI comes up fine
2)Then import volumes, volumes seen, reboot, and can't connect http or browse via network
output says: "getty repeating too quickly on port /dev/ttyv0 sleeping 30 secs"
3)Reflashed iso to USB stick and "upgrade" install = still no GUI
Going back to 9.2.1.8 old usb stick works.