keithmabrey
Cadet
- Joined
- Mar 12, 2012
- Messages
- 2
Hardware
Dell PowerEdge 800 w/ 4gb Ram
Adaptec 2420SA Controller
Sil 3114 Controller
I tried the GUI upgrade from 8.3 to 9.1 and it seemed to go well. On reboot FreeNAS loads and seems to enumerate all the hardware. It's during this that the boot process hangs, the last line written to the screen being aac0: COMMAND 0x877360c0 (TYPE 502) TIMEOUT AFTER 138 SECONDS.
Apparently 9.1.0 does not like the adaptec 2420SA controller that I'm using. I took it out and rebooted and I made it past where it previously hung and the freenas db was updated. I put the controller back in, rebooted and the boot process hangs.
I'd like to stick with 9.1 if I can so does anyone have any ideas how I can get past the error.
Otherwise, I'm hoping I can get back to 8.3.1
Dell PowerEdge 800 w/ 4gb Ram
Adaptec 2420SA Controller
Sil 3114 Controller
I tried the GUI upgrade from 8.3 to 9.1 and it seemed to go well. On reboot FreeNAS loads and seems to enumerate all the hardware. It's during this that the boot process hangs, the last line written to the screen being aac0: COMMAND 0x877360c0 (TYPE 502) TIMEOUT AFTER 138 SECONDS.
Apparently 9.1.0 does not like the adaptec 2420SA controller that I'm using. I took it out and rebooted and I made it past where it previously hung and the freenas db was updated. I put the controller back in, rebooted and the boot process hangs.
I'd like to stick with 9.1 if I can so does anyone have any ideas how I can get past the error.
Otherwise, I'm hoping I can get back to 8.3.1