I have FreeNAS setup, created a volume based on IDE disk just fine. Create a volume on same box that happens to be a RAID 5 set, on PERC4 controller, disk is seen just fine, /dev/amrd, size is correct, et. But when I create the volume, say /mnt/scsi, it shows up in the GUI, but when I click on the permissions item for the volume, I get 'sorry! an error has occured' dialog? And this same volume is not visible anywhere else in the GUI, including not listed under View All Volumes. Since I am new to FreeNAS, this seems odd, that it creates the volume, it appears, but is useless.