diedrichg
Wizard
- Joined
- Dec 4, 2012
- Messages
- 1,319
I'm running a Supermicro X10SLM-F-O with FreeNAS 9.2.1.8. I have had some reoccurring Ethernet error emails sent to me so I decided to investigate the cause further. It turns out the Intel i217LM gigabit controller may not be fully supported by FreeBSD but the Intel i210AT is.
The Supermicro motherboard manual is not specific in telling me which Ethernet port is which controller and using ifconfig only tells me I'm on igb0. Is there a shell command that will tell me the specifics of igb0?
And yes, i know I can just swap ports but it would be nice to have a working knowledge of my hardware first.
The Supermicro motherboard manual is not specific in telling me which Ethernet port is which controller and using ifconfig only tells me I'm on igb0. Is there a shell command that will tell me the specifics of igb0?
And yes, i know I can just swap ports but it would be nice to have a working knowledge of my hardware first.