Pete Van der Goore
Dabbler
- Joined
- Dec 30, 2013
- Messages
- 15
V 9.2.1.1&2 HP Proliant Micro server
My v 9.2.1 was running ok except for an error about security (security = user in smb.conf). It was recommended I update to 9.2.1.1 which I did with the updater. When I restored my config the console didn't report a web connect address and I can't connect to the web interface.
This is what I have tried:
Reloaded 9.2.1.1 from scratch. Got an address when I rebooted. Logged in to the GU! and restored the config. Web Gui gone again.
Reverted to 9.2.1 Same deal. So I rest to factory defaults. Got an address then tried an older config. Same problem.
Noticed 9.2.1.2 was available so I downloaded that and loaded it on a new usb stick. Same problem.
Any suggestions would be appreciated.
My v 9.2.1 was running ok except for an error about security (security = user in smb.conf). It was recommended I update to 9.2.1.1 which I did with the updater. When I restored my config the console didn't report a web connect address and I can't connect to the web interface.
This is what I have tried:
Reloaded 9.2.1.1 from scratch. Got an address when I rebooted. Logged in to the GU! and restored the config. Web Gui gone again.
Reverted to 9.2.1 Same deal. So I rest to factory defaults. Got an address then tried an older config. Same problem.
Noticed 9.2.1.2 was available so I downloaded that and loaded it on a new usb stick. Same problem.
Any suggestions would be appreciated.