Hi,
My hardware is H97M-G43, NIC Realtek RTL8111G GIGABIT LAN, Intel Celeron G1840, 8GB RAM + 3 HDD 1TB, FreeNAS 9.3 (latest stable build).
I can not setup this hardware to run with 1Gb/s network speed, it only works with 100Mb/s which is not acceptable for me. I found this post http://bluemedora.com/blog/correcting-link-speed-negotiation-issues-freenas-9x however when I run media 1000baseTX mediaopt full-duplex command network interface goes down with comment (from ifconfig) status: no carrier. When I go back to 100Mb/s it goes live again with no problems.
Reading through other replies to similar posts I'd like to say upfront it has nothing to do with my network setup - same hardware over the same cables run on 1Gb/s on windows with no issues.
I assume this has sth. to do with realtek driver for freeBSD. Any help would be appreciated ...
My hardware is H97M-G43, NIC Realtek RTL8111G GIGABIT LAN, Intel Celeron G1840, 8GB RAM + 3 HDD 1TB, FreeNAS 9.3 (latest stable build).
I can not setup this hardware to run with 1Gb/s network speed, it only works with 100Mb/s which is not acceptable for me. I found this post http://bluemedora.com/blog/correcting-link-speed-negotiation-issues-freenas-9x however when I run media 1000baseTX mediaopt full-duplex command network interface goes down with comment (from ifconfig) status: no carrier. When I go back to 100Mb/s it goes live again with no problems.
Reading through other replies to similar posts I'd like to say upfront it has nothing to do with my network setup - same hardware over the same cables run on 1Gb/s on windows with no issues.
I assume this has sth. to do with realtek driver for freeBSD. Any help would be appreciated ...