My pool has been scrubbing for a month and has a couple weeks to go at least, yet is only 69% done.
This is also with aggressive settings:
vfs.zfs.scrub_delay=0
vfs.zfs.top_maxinflight=128
vfs.zfs.resilver_min_time_ms=5000
vfs.zfs.resilver_delay=0
I have 150 disks (12 are idle) and only two have errors, none are failed or rebuilding.
" /dev/da29 [SAT], 1 Currently unreadable (pending) sectors"
" /dev/da11 [SAT], Failed SMART usage Attribute: 184 End-to-End_Error."
That said both those disks are online and doing the same IO as every other disk, I was hoping to finish the scrub before replacing them. Could this just be a byproduct of having a huge pool?
I have this error message as well, which I have a pending fix for (I doubled it to 4096) but I need to reboot for the change to go through.
Jan 18 14:07:17 fs05 mps1: Out of chain frames, consider increasing hw.mps.max_chains.
Any thoughts?
This is also with aggressive settings:
vfs.zfs.scrub_delay=0
vfs.zfs.top_maxinflight=128
vfs.zfs.resilver_min_time_ms=5000
vfs.zfs.resilver_delay=0
I have 150 disks (12 are idle) and only two have errors, none are failed or rebuilding.
" /dev/da29 [SAT], 1 Currently unreadable (pending) sectors"
" /dev/da11 [SAT], Failed SMART usage Attribute: 184 End-to-End_Error."
That said both those disks are online and doing the same IO as every other disk, I was hoping to finish the scrub before replacing them. Could this just be a byproduct of having a huge pool?
I have this error message as well, which I have a pending fix for (I doubled it to 4096) but I need to reboot for the change to go through.
Jan 18 14:07:17 fs05 mps1: Out of chain frames, consider increasing hw.mps.max_chains.
Any thoughts?