FJep
Dabbler
- Joined
- Mar 7, 2019
- Messages
- 38
Hi,
I am planning to replace a disk in a single disk stripe
There are two folders on that Vol (music, pictures, log), a rsync job copying these folders and a smb share.
I know I could remove the Vol and switch disks and create everything from scratch, but is there an easier way?
Greetings
Frank
I am planning to replace a disk in a single disk stripe
Code:
# zpool status pool: VolA1 state: ONLINE status: Some supported features are not enabled on the pool. The pool can still be used, but some features are unavailable. action: Enable all features using 'zpool upgrade'. Once this is done, the pool may no longer be accessible by software that does not support the features. See zpool-features(7) for details. scan: scrub repaired 0 in 0 days 03:01:50 with 0 errors on Sun Jun 21 03:01:58 2020 config: NAME STATE READ WRITE CKSUM VolA1 ONLINE 0 0 0 gptid/9ad8b20d-c0ea-11e7-b63e-7085c2464c1b ONLINE 0 0 0 errors: No known data errors
There are two folders on that Vol (music, pictures, log), a rsync job copying these folders and a smb share.
I know I could remove the Vol and switch disks and create everything from scratch, but is there an easier way?
Greetings
Frank