Qlogic ISP 2432 HBA on FreeNAS 9.1.1

[wRaul goycoolea]

Hi,

I'm working with FreeNAS 9.1.1 on a Dell Optiplex 7010 with 16GB of RAM, 4 Hard Disk, 1 SATA 3 500GB, and 3 SATA 2 1 TB Disks.

I have installed a Qlogic 2432 card on the machine and connected with Fiber to an StorageTek 6140 disk array. Before the upgrade to 9.1.1 I was able to see the connected disks on the array on the FreeNAS GUI and able to create shares and iscsi initiators over the FC disk.

After the upgrade to 9.1.1 the HBA no longer see the disk array and of course I'm not able to see and map the disk array volumes.

I already try adding the iso.ko and ispfw.ko to the /boot/modules and ran kldxref. Now appears that the cards are seen and the ISP firmware is loaded. On the logs no longer see a message about Qlogic Firmware cannot be load.

But still not able to see the array.

Any advice is welcome, I'm have a lot of disk space on the disk array and need to be able to use it ASAP.

Regards

 

[TechPlatforms]

This was caused by switching isp(4) into "TARGET" mode, which is required for target mode to work.
Please add the following loader tunables and retry:
hint.isp.0.role=2
hint.isp.1.role=2