Hello All.
When I setup FreeNAS 9.1, and Configure the first network card for the correct IP all is fine and dandy, then I log into the web interface and configure the next 3, when doing so I lose network connectivity to the box over the first NIC, so I have to over kvm set the ip for the first nic any time I edit any other nic's to get network connectivity back, upon doing so sometimes the box will never start responding to ping again even with re-setting the igb0 nic IP via console not even wiping all network config through cli and re-setting up works, and a re-install is needed. When I finally got it setup I had 4 different ip's on the 4 different network cards, but all traffic goes through igb0 making the others just useless, and setting LACP up does not work as it is not pingable, and also requires the resetting of the first nic's IP.
Hardware
SUPERMICRO SSG-6047R-E1R24L 4U
2x E5-2660
8x Crucial 16GB 240-Pin DDR3 SDRAM ECC
Any help is appreciated.
When I setup FreeNAS 9.1, and Configure the first network card for the correct IP all is fine and dandy, then I log into the web interface and configure the next 3, when doing so I lose network connectivity to the box over the first NIC, so I have to over kvm set the ip for the first nic any time I edit any other nic's to get network connectivity back, upon doing so sometimes the box will never start responding to ping again even with re-setting the igb0 nic IP via console not even wiping all network config through cli and re-setting up works, and a re-install is needed. When I finally got it setup I had 4 different ip's on the 4 different network cards, but all traffic goes through igb0 making the others just useless, and setting LACP up does not work as it is not pingable, and also requires the resetting of the first nic's IP.
Hardware
SUPERMICRO SSG-6047R-E1R24L 4U
2x E5-2660
8x Crucial 16GB 240-Pin DDR3 SDRAM ECC
Any help is appreciated.
Last edited by a moderator: