I'm very new to FreeNas...
I had my setup running quite happily. Unfortunately we are an entirely Mac-based household and I needed a PC to update some firmware on an SSD drive. The only suitable box I had available was my FreeNas box...
I removed the SSD FreeNas was booted on,
Hooked up the new SSD. Did what I needed to do and replaced my original SSD which *was* running FreeNas perfectly happily.
I expected things to just pick up where they left off. Instead I get an: "This is a FreeNas data disk and can not boot system. System halted" error.
How do I get past this please? I'm hoping I don't have to start from scratch... :-/
S
I had my setup running quite happily. Unfortunately we are an entirely Mac-based household and I needed a PC to update some firmware on an SSD drive. The only suitable box I had available was my FreeNas box...
I removed the SSD FreeNas was booted on,
Hooked up the new SSD. Did what I needed to do and replaced my original SSD which *was* running FreeNas perfectly happily.
I expected things to just pick up where they left off. Instead I get an: "This is a FreeNas data disk and can not boot system. System halted" error.
How do I get past this please? I'm hoping I don't have to start from scratch... :-/
S