Aephir
Dabbler
- Joined
- Apr 25, 2021
- Messages
- 47
I created a jail and (based on FreeBSD 13.1) an installed UniFi controller (pkg install unifi7), and I'm pretty sure I'm doing something wrong with the network setup.
I have set up a link aggregation (lagg1) for the TrueNAS system, and the jail is configured like my jail for Nextcloud (set up with the "all-in-one" script):
Basic properties:
None of the boxes checked (I initially checked the VNET, but then I couldn't install packages or ping names, only ping IPs (8.8.8.8 but not google.com)).
Network properties:
Although I have tried many combinations of changing the settings above, with no luck. The closest I got was once, when I navigated to https://10.0.30.68:8843 where it said "starting network application" (or something like that) briefly before it showed "HTTP Status 400 - Bad Request" upon refreshing (I had "Network properties" --> "interfaces" set to "lagg1:bridge0", but all else as shown above).
But other than that, I only see "HTTP Status 400 - Bad Request" if navigating to either http://10.0.30.68:8880 or https://10.0.30.68:8843.
I've searched around a bit (incl. finding this post), but I can't seem to find a setup that works. Any help/suggestions would be appreciated.
(EDIT: the jail gets the correct IP, and I can see it pop up in my network in my old Unifi controller running as a Home Assistant addon)
I have set up a link aggregation (lagg1) for the TrueNAS system, and the jail is configured like my jail for Nextcloud (set up with the "all-in-one" script):
Basic properties:
None of the boxes checked (I initially checked the VNET, but then I couldn't install packages or ping names, only ping IPs (8.8.8.8 but not google.com)).
Code:
vnet_default_interface: auto ip4_interface: lagg1 ipv4_address: 10.0.30.68 (my TrueNAS is on 10.0.30.27 on a 10.0.30.0/24 VLAN/subnet) ipv4_netmask: 24
Network properties:
Code:
interfaces: lagg1:bridge0
Although I have tried many combinations of changing the settings above, with no luck. The closest I got was once, when I navigated to https://10.0.30.68:8843 where it said "starting network application" (or something like that) briefly before it showed "HTTP Status 400 - Bad Request" upon refreshing (I had "Network properties" --> "interfaces" set to "lagg1:bridge0", but all else as shown above).
But other than that, I only see "HTTP Status 400 - Bad Request" if navigating to either http://10.0.30.68:8880 or https://10.0.30.68:8843.
I've searched around a bit (incl. finding this post), but I can't seem to find a setup that works. Any help/suggestions would be appreciated.
(EDIT: the jail gets the correct IP, and I can see it pop up in my network in my old Unifi controller running as a Home Assistant addon)