I'm trying to install 9.10 to an ASRock J1900 board (only 4GB for now). The installer boots, but it reboots after a few seconds around the time it reports "waiting for usbus0". There may be more output after this, but it's hard to say for sure.
Is it possible to use the grub 'e' option to add something at boot time so that I can capture the full boot trace over a serial interface? I've looked about for information on enabling the serial console for FreeBSD, but I've not found anything that's helped (I'm used to Linux, so FreeBSD is new to me).
I've tried running the installer from a USB CD-ROM, USB flash drive and a SATA drive. They all boot, but have the same problem.
Chris
Is it possible to use the grub 'e' option to add something at boot time so that I can capture the full boot trace over a serial interface? I've looked about for information on enabling the serial console for FreeBSD, but I've not found anything that's helped (I'm used to Linux, so FreeBSD is new to me).
I've tried running the installer from a USB CD-ROM, USB flash drive and a SATA drive. They all boot, but have the same problem.
Chris