BUILD HP DL380 G9 raid controller p440ar

[gniewko84]

Hey,
The server has the following error:
313-hpe Smart Storage Battery 1 failure - Battery Shutdown Event Code: 0x0400.
and OS couldn't boot because the cache of the RAID controller was permanently disabled.

Action has been taken:
Firmware of RAID controller updated to the latest version 7.00. The batter was replaced.
The error of the battery is gone. But still, OS can't boot because it isn't detected any logical drives.
I go to IP -> smart array and the array exists in raid10. I set boot logical volume as the primary.
Boot mode I leave it as it was: Legacy bios mode.
Still didn't help.
Any advice?? What to do?

Thanks in advance

 

[jgreco]

The following article applies to you:

https://www.ixsystems.com/community...s-and-why-cant-i-use-a-raid-controller.81931/

 

[HoneyBadger]

Even if this was being used with a RAID card instead of an HBA, there would normally be a separate bootable drive, as installing FreeNAS onto a logical drive renders it unusable for storage.

Begging the obvious question - "is this even a FreeNAS server you're talking about here?"

 

[gniewko84]

Thank you for your answer. I will try to give you more details.

After update if I will go to array settings you will see:

.

Its 1u server HP dl360 gen9.
more info:

Document Display | HPE Support Center

support.hpe.com