Hello all.
New here .. but of course I'm in need of help.
I had a drive that was failing. So in shell I zpool replace ZFS_Pool /dev/ad6/
which started happily and I went to bed. This morning. I looked at the status and
it was stuck at 52.46% remaining - I waited a while (1 hour) and the time remaining kept going up and up
with no change in % done.
I'm getting Some sort of Smart error on another drive. /dev/ad8 which I think is causing this.
will post that when I get home.. but
1. is it safe to offline ad8?
2. should I abort the resilver (and if so, how?)
3. what should I do ?
* of course I have no backup of all my data.. because I'm a nob.
Note: the system hasn't been 100% for a while, it goes crashes every now and then, but usually a hard reboot seems to "fix it", also using an old version of FreeNas (7RC1) or something. Too afraid to upgrade it.
thanks for any help.
Ian
New here .. but of course I'm in need of help.
I had a drive that was failing. So in shell I zpool replace ZFS_Pool /dev/ad6/
which started happily and I went to bed. This morning. I looked at the status and
it was stuck at 52.46% remaining - I waited a while (1 hour) and the time remaining kept going up and up
with no change in % done.
I'm getting Some sort of Smart error on another drive. /dev/ad8 which I think is causing this.
will post that when I get home.. but
1. is it safe to offline ad8?
2. should I abort the resilver (and if so, how?)
3. what should I do ?
* of course I have no backup of all my data.. because I'm a nob.
Note: the system hasn't been 100% for a while, it goes crashes every now and then, but usually a hard reboot seems to "fix it", also using an old version of FreeNas (7RC1) or something. Too afraid to upgrade it.
thanks for any help.
Ian