MarkJohnson
Dabbler
- Joined
- Dec 27, 2011
- Messages
- 16
I finally setup TrueNAS and have it setup as SMB server and all is well.
I then noticed that TrueNAS is using +75Watts at idle.
I notice I have a GTX 1060 GPU installed.
I remove the GTX 1060 and when I start the server bavk again, it give 1 long, 4-short beeps, which shoukd be no video. Then I hear anothe single short beep, like it booted into TrueNAS. but I can't log into the server. It acts like it doesn't exist?
Maybe it didn't boot into TrueNAS, maybe it booted to BIOS and wants more configuration for headless operation?
So, my question, is what setting do I make to go into headless mode, to bypass any video, so I hopefully use less power?
I have a Ryzen system. 3600X, Asus Prime X470-Pro.
Or maybe does the 3600x use a lot of power in idle state, Same with X480 board, does it use up abnormal power as well?
Any help will be gratefully appreciated.
I then noticed that TrueNAS is using +75Watts at idle.
I notice I have a GTX 1060 GPU installed.
I remove the GTX 1060 and when I start the server bavk again, it give 1 long, 4-short beeps, which shoukd be no video. Then I hear anothe single short beep, like it booted into TrueNAS. but I can't log into the server. It acts like it doesn't exist?
Maybe it didn't boot into TrueNAS, maybe it booted to BIOS and wants more configuration for headless operation?
So, my question, is what setting do I make to go into headless mode, to bypass any video, so I hopefully use less power?
I have a Ryzen system. 3600X, Asus Prime X470-Pro.
Or maybe does the 3600x use a lot of power in idle state, Same with X480 board, does it use up abnormal power as well?
Any help will be gratefully appreciated.