Rickle
Dabbler
- Joined
- Aug 14, 2013
- Messages
- 38
I am running FreeNas 9.3 stable on a 16GB USB drive. Today I thought I would try the new update feature in the FreeNas GUI. I made sure i was still in the "stable" train.
I backed up my config and simply downloaded the latest updates via the GUI and pressed the install button.
(sorry, i did not take note of all the required updates being installed)
15 minutes later, once all updates were downloaded and installed, the system automatically rebooted I get the following error message on a connected monitor.
Grub loading..
Welcome to GRUB!
error: checksum verification failed.
entering rescue mode..
I am convinced i can fix this by re-installing FreeNas on the USB drive and recovering from my backup but would rather try to identify the issue.
any thoughts?
I backed up my config and simply downloaded the latest updates via the GUI and pressed the install button.
(sorry, i did not take note of all the required updates being installed)
15 minutes later, once all updates were downloaded and installed, the system automatically rebooted I get the following error message on a connected monitor.
Grub loading..
Welcome to GRUB!
error: checksum verification failed.
entering rescue mode..
I am convinced i can fix this by re-installing FreeNas on the USB drive and recovering from my backup but would rather try to identify the issue.
any thoughts?