Hi to everyone
Im new to the Forum ..but not new to FreeNas ...having used it for several years now ..
But recently tried to include some larger hard drives 3tb + for more data storage space ..
This led to issues as I was and still am using UFS to a large degree ..
I therefore built a later system having gone from version 7xx to 9.2 as it is now ..
9.2 being chosen deliberately it being the last version to support UFS.
I have an enormous amount of stored data ..so was reluctant to complete the move to ZFS.
My system is totally stable ...or at least it was...until I had a very abrupt power outage .
..resulting in many hours of disk/data repair.
All now sorted ..but I didnt want to go through that again so bought a PowerCool 1500VA UPS ..
My problem now is how to connect it having never used one before.
Does Freenas 9.2 even support this UPS ..?
I have found the relevant section in the webgui ...but sadly PowerCool doesn't appear in the list.
Are there drivers I can add to give me support ?
Many thanks for reading this.
..and hopefully I can get some help on this issue.
I'm including a picture of the UPS
rgds
VS
Spec of the PCUPS1500VA UPS :-
Built in AVR
• DC Cold Start
• Audible Alarm
• USB Connectivity
• Intelligent CPU Control
• Wide Input Range
• Software Monitoring included (Serial # on CD Sleeve)
• Compatible with generators
• Strong EMI compatibility, no EMI to load
• Protection against Surge, Over / Under voltage
Im new to the Forum ..but not new to FreeNas ...having used it for several years now ..
But recently tried to include some larger hard drives 3tb + for more data storage space ..
This led to issues as I was and still am using UFS to a large degree ..
I therefore built a later system having gone from version 7xx to 9.2 as it is now ..
9.2 being chosen deliberately it being the last version to support UFS.
I have an enormous amount of stored data ..so was reluctant to complete the move to ZFS.
My system is totally stable ...or at least it was...until I had a very abrupt power outage .
..resulting in many hours of disk/data repair.
All now sorted ..but I didnt want to go through that again so bought a PowerCool 1500VA UPS ..
My problem now is how to connect it having never used one before.
Does Freenas 9.2 even support this UPS ..?
I have found the relevant section in the webgui ...but sadly PowerCool doesn't appear in the list.
Are there drivers I can add to give me support ?
Many thanks for reading this.
..and hopefully I can get some help on this issue.
I'm including a picture of the UPS
rgds
VS
Spec of the PCUPS1500VA UPS :-
Built in AVR
• DC Cold Start
• Audible Alarm
• USB Connectivity
• Intelligent CPU Control
• Wide Input Range
• Software Monitoring included (Serial # on CD Sleeve)
• Compatible with generators
• Strong EMI compatibility, no EMI to load
• Protection against Surge, Over / Under voltage
Attachments
Last edited: