did a disk replace then moved disk, confused about how to fix

[odoyle]

Hi, I think I did things incorrectly, and I'm not sure how to best resolve it. I was replacing a disk in a zpool via gui, and did "replace" and selected the replacement disk which was plugged into an extra slot. When it was done resilvering, I wanted to remove the old drive, and put the "new" drive in the old drive's slot. When I did that, now it can't seem to recognize the disk:

So I thought ok maybe I can just replace it with itself, but then it says this:

Pretty sure I should have offlined the old, removed it, then plugged the new one in the same slot and then did replace.. but now that I am in this situation, what is the best way to resolve?

Thanks

 

[sretalla]

You're using an ancient version of the product... as I recall it, replacing a disk in a GELI encrypted pool required a re-key, so that's probably what the warning is talking about.

See if you can make sense of this:

8. Storage — FreeNAS®11.2-U8 User Guide Table of Contents

www.ixsystems.com

 

[odoyle]

Sorry, I meant to include this screenshot.. I suppose I could click "force" and resilver it again..

I know I'm using an ancient version, now I'm a bit afraid how I would upgrade and if it isn't broken, I guess I'm ok with this old version

 

[sretalla]

I suppose I could click "force" and resilver it again..

That sounds reasonable... you could also wipe it from the disks view first to avoid that warning/blockage.