Hello,
Following the advice kindly given here I extended a pool. I want to make sure I've done things right. I pressed add cache, then added the disk to read cache. After that I went over to shell and entered the command:
(misradpool/misraddata is the path to the dataset).
I noticed a warning when I opened up the shell saying:
"Setting changed through the CLI are not written to the configuration database and will be reset on reboot"
So I'm not sure I did everything right and I'm not sure what that warning meant.
I would greatly appreciate any help.
Also if you read the original thread (basically there's a lag when writing and we don't know why) I would appreciate any comment or direction to solving this problem.
Thank you.
Following the advice kindly given here I extended a pool. I want to make sure I've done things right. I pressed add cache, then added the disk to read cache. After that I went over to shell and entered the command:
Code:
zfs set secondarycache=metadata misradpool/misraddata
(misradpool/misraddata is the path to the dataset).
I noticed a warning when I opened up the shell saying:
"Setting changed through the CLI are not written to the configuration database and will be reset on reboot"
So I'm not sure I did everything right and I'm not sure what that warning meant.
I would greatly appreciate any help.
Also if you read the original thread (basically there's a lag when writing and we don't know why) I would appreciate any comment or direction to solving this problem.
Thank you.
Last edited: