FreeNASmike
Dabbler
- Joined
- Mar 13, 2017
- Messages
- 13
Hi there
Am just about to pull the pin on this new build:
----------------------
MOBO: http://www.supermicro.com/products/motherboard/Xeon/D/X10SDV-12C-TLN4F.cfm
CASE: https://www.supermicro.com.tw/products/chassis/tower/721/SC721TQ-250B
RAM: Kingston 32GB DDR4 2133 Reg ECC (x2)
STORAGE DRIVES: HGST 3.5in 26.1MM 6000GB 128MB 7200RPM SAS 512E ULTRA ISE (x4)
HBA: https://www.broadcom.com/products/storage/host-bus-adapters/sas-9211-8i
----------------------
It was suggested to me to look at a newer generation HBA card (chipset) so I was thinking of substituting for the following instead:
https://www.broadcom.com/products/storage/host-bus-adapters/sas-9300-8i#specifications
Does anyone know if this card will work fine with my RAIDZ2 setup (ie. will it be able to be flashed into IT mode etc without issue)?
Am just about to pull the pin on this new build:
----------------------
MOBO: http://www.supermicro.com/products/motherboard/Xeon/D/X10SDV-12C-TLN4F.cfm
CASE: https://www.supermicro.com.tw/products/chassis/tower/721/SC721TQ-250B
RAM: Kingston 32GB DDR4 2133 Reg ECC (x2)
STORAGE DRIVES: HGST 3.5in 26.1MM 6000GB 128MB 7200RPM SAS 512E ULTRA ISE (x4)
HBA: https://www.broadcom.com/products/storage/host-bus-adapters/sas-9211-8i
----------------------
It was suggested to me to look at a newer generation HBA card (chipset) so I was thinking of substituting for the following instead:
https://www.broadcom.com/products/storage/host-bus-adapters/sas-9300-8i#specifications
Does anyone know if this card will work fine with my RAIDZ2 setup (ie. will it be able to be flashed into IT mode etc without issue)?