paradoxiom
Patron
- Joined
- Jun 16, 2015
- Messages
- 239
I updated, all was fine, then I read a post somewhere about SMART not being necessary to be turned on for the boot device (SD card/USB mirror), so I went to Storage>View Disks, clicked the boot device opened the window and unticked SMART, clicked ok, then I get some log message like:
Then I checked services, SMART was off, so I clicked to turn it on, it just says at the top in the green banner that appears for a few seconds something like failed to start service.
So now the SMART service isn't running at all, but it's still ticked as being on for the boot device, as well as all the others.
I rolled back to the previous version that I'm currently running, FreeNAS-11.1-RELEASE, and SMART service runs fine etc.
I'm thinking that I am probably just going to have to do a clean install with U1, but I'd really rather not have to do that whole thing again as I'm in the middle of moving house (tomorrow actually).
Also thinking I will just wait until U2 is released because the log spam that everyone is getting is annoying too.
Since I'm rolled back and not on the boot with the faulty SMART service would it even be helpful to give any logs?
I actually tried rolling back, deleting the U1 download/boot, and redownloading and installing it, but SMART service still fails to start so I rolled back again.
Any suggestions? Willing to give as much info as I can to get this sorted while I've got the energy.
Thanks in advance.
Code:
smartd[88869]: Unable to register device /dev/da8 (no Directive -d removable). Exiting.
Then I checked services, SMART was off, so I clicked to turn it on, it just says at the top in the green banner that appears for a few seconds something like failed to start service.
So now the SMART service isn't running at all, but it's still ticked as being on for the boot device, as well as all the others.
I rolled back to the previous version that I'm currently running, FreeNAS-11.1-RELEASE, and SMART service runs fine etc.
I'm thinking that I am probably just going to have to do a clean install with U1, but I'd really rather not have to do that whole thing again as I'm in the middle of moving house (tomorrow actually).
Also thinking I will just wait until U2 is released because the log spam that everyone is getting is annoying too.
Since I'm rolled back and not on the boot with the faulty SMART service would it even be helpful to give any logs?
I actually tried rolling back, deleting the U1 download/boot, and redownloading and installing it, but SMART service still fails to start so I rolled back again.
Any suggestions? Willing to give as much info as I can to get this sorted while I've got the energy.
Thanks in advance.