I am upgrading my pool to larger drives and found an issue, system is a SuperMicro X10 based board, using 8 onboard SATA connections for 8 data drives in the pool. Drives are all matched (or were before I started this upgrade). OS is 11.1-u7. Drives were Seagate Enterprise 1tb going to HGST DC-HC510 10TB drives.
I checked the resilver priority check box, which I thought would limit the speed of resilver during the hours between the noted times. I'm currently getting full speed which is a bit of a performance hit and wondering if there is a way to change this so that resilver during active hours is slower, and full speed outside of those hours. Basically I'm certain I've got something wrong in my config and hoping someone can help/
Through a web search I found this page, and wondering if I need to set this up so that the priority checkbox has something to fall back to. https://www.ixsystems.com/blog/library/sequential-scrub-and-resilver/
My plan now is to again only swap drives on my way out the door at the end of work to save some performance for my users. But I got 2 done this morning and the first last night, so not too many left.
I checked the resilver priority check box, which I thought would limit the speed of resilver during the hours between the noted times. I'm currently getting full speed which is a bit of a performance hit and wondering if there is a way to change this so that resilver during active hours is slower, and full speed outside of those hours. Basically I'm certain I've got something wrong in my config and hoping someone can help/
Through a web search I found this page, and wondering if I need to set this up so that the priority checkbox has something to fall back to. https://www.ixsystems.com/blog/library/sequential-scrub-and-resilver/
My plan now is to again only swap drives on my way out the door at the end of work to save some performance for my users. But I got 2 done this morning and the first last night, so not too many left.