Gen8 Runner
Contributor
- Joined
- Aug 5, 2015
- Messages
- 103
Hey there,
like, i think many, I am at the moment upgrading from FreeNAS to TrueNAS.
My old pool in FreeNAS was encrypted, so I also wanted to change to the new encryption-algorhythm in TrueNAS and consequently did following:
1. Checked, if all snapshots were replicated to my BackupServer
2. Destroyed the pool on my main TrueNAS machine
3. Chose "Restore" on Tasks -> Replication tasks
4. Started replication
All snapshots were pulled from my backup-machine to my main TrueNAS machine, but immediately after replication starts, there is a lock on the dataset and I cannot change the permissions. Consequently it is not possible to access the data.
What to do, to use it like always, for SMB sharing etc.?
I already tried zfs set readonly=off Pool/Dataset, but it still has the lock and I cannot do anything else.
Any ideas?
Thanks a lot!
like, i think many, I am at the moment upgrading from FreeNAS to TrueNAS.
My old pool in FreeNAS was encrypted, so I also wanted to change to the new encryption-algorhythm in TrueNAS and consequently did following:
1. Checked, if all snapshots were replicated to my BackupServer
2. Destroyed the pool on my main TrueNAS machine
3. Chose "Restore" on Tasks -> Replication tasks
4. Started replication
All snapshots were pulled from my backup-machine to my main TrueNAS machine, but immediately after replication starts, there is a lock on the dataset and I cannot change the permissions. Consequently it is not possible to access the data.
What to do, to use it like always, for SMB sharing etc.?
I already tried zfs set readonly=off Pool/Dataset, but it still has the lock and I cannot do anything else.
Any ideas?
Thanks a lot!