Michael De Cou
Explorer
- Joined
- Aug 12, 2016
- Messages
- 50
Hi all,
I have been running an iocage jail for Plex, using a static IP address over a bridge. When I first setup the jail on 11.1, I used the GUI in Freenas and was able to set the IP address and netmask in the wizard, and I did not have to select the IPv4 Interface.
I have just re-created the jail using 11.2 to get to the p7 release, and I am now required to select the interface. The problem i find is that if I select vnet0, i get an error stating that there is a vnet failure. The problem is that if i use any other interfaces listed, I get no connectivity. Any suggestions?
I have been running an iocage jail for Plex, using a static IP address over a bridge. When I first setup the jail on 11.1, I used the GUI in Freenas and was able to set the IP address and netmask in the wizard, and I did not have to select the IPv4 Interface.
I have just re-created the jail using 11.2 to get to the p7 release, and I am now required to select the interface. The problem i find is that if I select vnet0, i get an error stating that there is a vnet failure. The problem is that if i use any other interfaces listed, I get no connectivity. Any suggestions?