Judd Bonham
Cadet
- Joined
- Dec 19, 2016
- Messages
- 9
Before I get the hammer for creating yet another Plex thread, I will say that I have spent the last week reading articles on how to fix the problem I am having. I have been using FreeNAS for quite a while but I am not versed in Shell/CLI commands or how to use them. I have however been successful only once before in creating and installing Plex in a jail. I did this in 9.10 U3 and when it came time I updated to U4.
At this point my machine has been updated to FreeNAS 11 which, I believe is where the problem started. I have never had problems getting FreeNAS installed initially. It is obvious however that others have been able to make Plex see the mount points but I cannot. I am not sure why. I used the instructions for installing Plex in a jail that are located at the link below.
https://forums.freenas.org/index.ph...ombi-transmission-nzbget-sabnzbd-organizr.58/
Issue being that when I follow those instructions everything seems fine until I try to navigate to the mount points so Plex can see the content I have stored and populate all the appropriate categories. If someone could help me with this it would be appreciated. I have included a screen shot of the issue below and hope it will be obvious to someone else what the issues could be.
Thanks!
At this point my machine has been updated to FreeNAS 11 which, I believe is where the problem started. I have never had problems getting FreeNAS installed initially. It is obvious however that others have been able to make Plex see the mount points but I cannot. I am not sure why. I used the instructions for installing Plex in a jail that are located at the link below.
https://forums.freenas.org/index.ph...ombi-transmission-nzbget-sabnzbd-organizr.58/
Issue being that when I follow those instructions everything seems fine until I try to navigate to the mount points so Plex can see the content I have stored and populate all the appropriate categories. If someone could help me with this it would be appreciated. I have included a screen shot of the issue below and hope it will be obvious to someone else what the issues could be.
Thanks!