I started to flash my H310 last night. I removed all other RAID cards in the Dell r710 and installed the new H310. Have not yet connected the wires to the backplane. Using following instructions:
https://tylermade.net/2017/06/27/ho...-lsi-9211-8i-firmware-hba-for-freenas-unraid/
Loaded DOS on thumbdrive with LSI Firmware files from http://www.mediafire.com/file/6mtie10d9ud6675/LSI-9211-8i.zip
1. I got the SAS address.
2. When i do next command
3. This is where i get a little confused... next step is
4. Reboot server.
5. at prompt
when I type
Any ideas?
https://tylermade.net/2017/06/27/ho...-lsi-9211-8i-firmware-hba-for-freenas-unraid/
Loaded DOS on thumbdrive with LSI Firmware files from http://www.mediafire.com/file/6mtie10d9ud6675/LSI-9211-8i.zip
1. I got the SAS address.
2. When i do next command
megarec.exe -writesbr 0 sbrempty.bin
, I do not get an error. It says 'chip is in fusion mode... Success'. From my understanding, fusion mode = IT3. This is where i get a little confused... next step is
megarec.exe -cleanflash 0
. I skip this step since i am already in IT mode.4. Reboot server.
5. at prompt
sas2flsh.exe -o -f 6GBPSAS.fw
to flash Dell HBA FW. This is where I get issues. It begins but then fails "firmware download failed, Due to error reaminig commands will not be executed... exiting sas2flash".when I type
sas2flsh.exe -listall
, I get "LSI SAS: SAS2008(??), controller is not operational..."Any ideas?
Last edited by a moderator: