Hi All.
I know, that this is not the way you like it, I know. But I cant find any other place with peoples familiar so much with Perc H310 crossflashing. I bought an old controller and wanted to use it to build raid 5 in my windows machine. I had some problems with it, it hung every time just a few moments after computer stared. I wanted to upgrade firmware, but it was not an easy task as orginal software told me "Your computer is not Dell, i'm not going to update controller". So i found threads about crossflashing. I wanted to flash the device as it was described here: https://www.ixsystems.com/community...shing-lsi-9211-9300-9311-hba-and-variants.54/ and here: https://techmattr.wordpress.com/201...-flashing-to-it-mode-dell-perc-h200-and-h310/ . Bacically what I did was:
H310 UEFI:
And now something strange: Disks are visible in system. Bui I don't get <Ctrl-C> prompt to enter the configuration utility. And now I'm stuck. Could anyone help me with this issue?
Thank you in advance
Smok.
I know, that this is not the way you like it, I know. But I cant find any other place with peoples familiar so much with Perc H310 crossflashing. I bought an old controller and wanted to use it to build raid 5 in my windows machine. I had some problems with it, it hung every time just a few moments after computer stared. I wanted to upgrade firmware, but it was not an easy task as orginal software told me "Your computer is not Dell, i'm not going to update controller". So i found threads about crossflashing. I wanted to flash the device as it was described here: https://www.ixsystems.com/community...shing-lsi-9211-9300-9311-hba-and-variants.54/ and here: https://techmattr.wordpress.com/201...-flashing-to-it-mode-dell-perc-h200-and-h310/ . Bacically what I did was:
H310 UEFI:
- Run the following commands in the DOS prompt:
- megacli.exe -AdpAllInfo -aAll -page 20 Write down SAS address.
- megarec.exe -writesbr 0 sbrempty.bin If this fails move on to next step.
- megarec.exe -cleanflash 0
- Reboot into UEFI shell and run the following commands:
- sas2flash.efi -o -f 6GBPSAS.FW Reboot and return to UEFI shell.
- sas2flash.efi -o -f 2118it.bin ##### This is the only change - I used 2118IR.bin not IT.
- sas2flash_p19.efi -o -sasadd 500xxxxxxxxxxxxx
And now something strange: Disks are visible in system. Bui I don't get <Ctrl-C> prompt to enter the configuration utility. And now I'm stuck. Could anyone help me with this issue?
Thank you in advance
Smok.