I see some issues with da1, but how does that figure in to the GUI issue?
[root@freenas] ~# smartctl -a /dev/da1
smartctl 6.4 2015-06-04 r4109 [FreeBSD 10.3-RELEASE amd64] (local build)
Copyright (C) 2002-15, Bruce Allen, Christian Franke,
www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Hitachi Ultrastar 7K3000
Device Model: Hitachi HUA723020ALA640
Serial Number: MK0151YFKMJ59A
LU WWN Device Id: 5 000cca 223f32644
Firmware Version: MK7OAA10
User Capacity: 2,000,398,934,016 bytes [2.00 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 2.6, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Mon Feb 17 11:00:03 2020 EST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 28) seconds.
Offline data collection
capabilities: (0x5b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
No Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 325) minutes.
SCT capabilities: (0x003d) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0
2 Throughput_Performance 0x0005 133 133 054 Pre-fail Offline - 91
3 Spin_Up_Time 0x0007 205 205 024 Pre-fail Always - 333 (Average 276)
4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 185
5 Reallocated_Sector_Ct 0x0033 100 100 005 Pre-fail Always - 0
7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0
8 Seek_Time_Performance 0x0005 125 125 020 Pre-fail Offline - 30
9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 13991
10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 47
192 Power-Off_Retract_Count 0x0032 098 098 000 Old_age Always - 3447
193 Load_Cycle_Count 0x0012 098 098 000 Old_age Always - 3447
194 Temperature_Celsius 0x0002 206 206 000 Old_age Always - 29 (Min/Max 19/58)
196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 0
197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 870
SMART Error Log Version: 1
ATA Error Count: 958 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 958 occurred at disk power-on lifetime: 13972 hours (582 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 11 6f 6e 60 02 Error: ICRC, ABRT at LBA = 0x02606e6f = 39874159
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 10 00 6e 60 40 00 00:52:06.701 READ FPDMA QUEUED
60 80 10 f8 6c 60 40 00 00:52:06.697 READ FPDMA QUEUED
60 80 10 20 80 53 40 00 00:52:06.694 READ FPDMA QUEUED
60 80 08 18 7f 53 40 00 00:52:06.694 READ FPDMA QUEUED
60 80 00 48 6b 48 40 00 00:52:06.689 READ FPDMA QUEUED
Error 957 occurred at disk power-on lifetime: 13972 hours (582 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 11 37 a6 64 02 Error: ICRC, ABRT at LBA = 0x0264a637 = 40150583
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 08 d8 75 45 40 00 00:52:06.676 READ FPDMA QUEUED
60 80 00 c8 a5 64 40 00 00:52:06.669 READ FPDMA QUEUED
60 80 10 38 a5 64 40 00 00:52:06.660 READ FPDMA QUEUED
60 80 08 30 a4 64 40 00 00:52:06.660 READ FPDMA QUEUED
60 80 00 48 9d 58 40 00 00:52:06.660 READ FPDMA QUEUED
Error 956 occurred at disk power-on lifetime: 13972 hours (582 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 21 8f a4 64 02 Error: ICRC, ABRT at LBA = 0x0264a48f = 40150159
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 10 38 a5 64 40 00 00:52:06.653 READ FPDMA QUEUED
60 80 08 48 9d 58 40 00 00:52:06.653 READ FPDMA QUEUED
60 80 00 30 a4 64 40 00 00:52:06.652 READ FPDMA QUEUED
2f 00 01 10 00 00 00 00 00:52:06.652 READ LOG EXT
60 80 10 38 a5 64 40 00 00:52:06.640 READ FPDMA QUEUED
Error 955 occurred at disk power-on lifetime: 13972 hours (582 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 41 87 9d 58 02 Error: ICRC, ABRT at LBA = 0x02589d87 = 39361927
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 10 38 a5 64 40 00 00:52:06.640 READ FPDMA QUEUED
60 80 08 30 a4 64 40 00 00:52:06.640 READ FPDMA QUEUED
60 80 00 48 9d 58 40 00 00:52:06.639 READ FPDMA QUEUED
ea 00 00 00 00 00 00 00 00:52:03.618 FLUSH CACHE EXT
61 08 00 88 87 e0 40 00 00:52:03.617 WRITE FPDMA QUEUED
Error 954 occurred at disk power-on lifetime: 13972 hours (582 days + 4 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
84 51 51 af 86 4c 02 Error: ICRC, ABRT at LBA = 0x024c86af = 38569647
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 80 10 40 40 4f 40 00 00:52:02.876 READ FPDMA QUEUED
60 80 00 38 3f 4f 40 00 00:52:02.872 READ FPDMA QUEUED
60 80 08 80 86 4c 40 00 00:52:02.870 READ FPDMA QUEUED
60 80 10 68 84 4c 40 00 00:52:02.862 READ FPDMA QUEUED
60 80 00 a8 31 44 40 00 00:52:02.861 READ FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 13990 -
# 2 Short offline Completed without error 00% 13989 -
# 3 Short offline Completed without error 00% 13988 -
# 4 Short offline Completed without error 00% 13987 -
# 5 Short offline Completed without error 00% 13986 -
# 6 Short offline Completed without error 00% 13985 -
# 7 Short offline Completed without error 00% 13984 -
# 8 Short offline Completed without error 00% 13983 -
# 9 Short offline Completed without error 00% 13982 -
#10 Short offline Completed without error 00% 13981 -
#11 Short offline Completed without error 00% 13980 -
#12 Short offline Completed without error 00% 13979 -
#13 Short offline Completed without error 00% 13978 -
#14 Short offline Completed without error 00% 13977 -
#15 Short offline Completed without error 00% 13976 -
#16 Short offline Completed without error 00% 13975 -
#17 Short offline Completed without error 00% 13974 -
#18 Short offline Completed without error 00% 13973 -
#19 Short offline Completed without error 00% 13973 -
#20 Short offline Completed without error 00% 13972 -
#21 Short offline Completed without error 00% 13971 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
[root@freenas] ~#