Hi,
I recently had a flash drive with FreeNas 9.3 running on it die the other day. So, I got a new flash drive and installed FreeNas 9.3 again and everything was working good. I ran into problems when I was setting up my user and permissions in FreeNas GUI. I could see my data but, it was read only? I then decided to create a new data set because my original data from my first install was not on a data set it was only in the pool. After creating the new data set my data does not appear. I know my data is still on the disk because of the total use of my disk. I need some help figuring out how to connect my data to this new data set. I am still very new with FreeNas but, eager to learn. I found a thread on the forum that sounds similar to what I have encountered,,.
https://forums.freenas.org/index.ph...reating-a-dataset-need-consoling-advice.8681/
I would assume my steps would be identical to the ones in this thread.
Any help would be greatly appreciated,
Thank You
I recently had a flash drive with FreeNas 9.3 running on it die the other day. So, I got a new flash drive and installed FreeNas 9.3 again and everything was working good. I ran into problems when I was setting up my user and permissions in FreeNas GUI. I could see my data but, it was read only? I then decided to create a new data set because my original data from my first install was not on a data set it was only in the pool. After creating the new data set my data does not appear. I know my data is still on the disk because of the total use of my disk. I need some help figuring out how to connect my data to this new data set. I am still very new with FreeNas but, eager to learn. I found a thread on the forum that sounds similar to what I have encountered,,.
https://forums.freenas.org/index.ph...reating-a-dataset-need-consoling-advice.8681/
I would assume my steps would be identical to the ones in this thread.
Any help would be greatly appreciated,
Thank You