cyberlink01
Cadet
- Joined
- Apr 19, 2019
- Messages
- 3
Ill start by saying this is my home network so I can mod on the fly.
My FreeNas server is
I have 4x 40Gb ports on my blade server plugged into the switch and configured with IPoIB with one server setup with OpenSM. Those servers are Centos7 and communicate over the IPoIB just fine. At this time I have the default Infiniband partition configured to 10Gb. It was at 40Gb but was reconfigured for testing.
When I boot the freenas server mlx4 gives an error I am trying to figure out.
It does appear to recognize the card.
I also noted that the card is configured for ether
Im assuming the issue is the entry that states "Required capability exceeded device limits" Im just not sure what compatibility it is referring to.
Any help would be appreciated.
My FreeNas server is
- FreeNAS-11.2-U3
- dual quad core E5405 CPU'S
- 32g of ECC ram
- 18Tb of drive space
- Internal Intel Ethernet card
- Mellanox MT26418 (40Gb)
I have 4x 40Gb ports on my blade server plugged into the switch and configured with IPoIB with one server setup with OpenSM. Those servers are Centos7 and communicate over the IPoIB just fine. At this time I have the default Infiniband partition configured to 10Gb. It was at 40Gb but was reconfigured for testing.
When I boot the freenas server mlx4 gives an error I am trying to figure out.
Code:
mlx4_en mlx4_core0: Activating port:1 mlxen0: Ethernet address: 00:02:c9:5a:65:9a mlx4_en: mlx4_core0: Port 1: Using 8 TX rings mlxen0: link state changed to DOWN mlx4_en: mlx4_core0: Port 1: Using 8 RX rings mlx4_en: mlxen0: Using 8 TX rings mlx4_en: mlxen0: Using 8 RX rings mlx4_en: mlxen0: Initializing port mlx4_core0: command INIT_PORT (0x9) failed: in_param=0x0, in_mod=0x1, op_mod=0x0, fw status = 0x8 mlx4_core0: Required capability exceeded device limits mlx4_en: mlxen0: Failed Initializing port
It does appear to recognize the card.
Code:
mlx4_core0@pci0:3:0:0: class=0x0c0600 card=0x002215b3 chip=0x673215b3 rev=0xb0 hdr=0x00 vendor = 'Mellanox Technologies' device = 'MT26418 [ConnectX VPI PCIe 2.0 5GT/s - IB DDR / 10GigE]' class = serial bus
I also noted that the card is configured for ether
Code:
sys.device.mlx4_core0.mlx4_port2: eth sys.device.mlx4_core0.mlx4_port1: eth sys.device.mlx4_core0.board_id: MT_0F90120008 sys.device.mlx4_core0.hca: MT26418 sys.device.mlx4_core0.fw_ver: 2.9.1810
Im assuming the issue is the entry that states "Required capability exceeded device limits" Im just not sure what compatibility it is referring to.
Any help would be appreciated.