chrisk2305
Dabbler
- Joined
- Feb 5, 2018
- Messages
- 18
Hi guys,
I would need your help. I have a FreeNAS 11.3 machine with a Mellanox ConnectX-3 40Gbe / IB Single Port installed.
The interface does not show up in the list of network interfaces but the driver seems to be loaded:
This card was set to ETH mode in Windows previously. Maybe I need to set the card to ETH mode in FreeNAS again? I read something about a system tunable to accomplish that (sys.device.mlx4_core0.mlx4_port0 = eth) but I am not sure how to do that and find the right "device path".
Can somebody please assist?
Thanks in advance!
Chris
I would need your help. I have a FreeNAS 11.3 machine with a Mellanox ConnectX-3 40Gbe / IB Single Port installed.
The interface does not show up in the list of network interfaces but the driver seems to be loaded:
Code:
pciconf -lv | grep Mellanox -C 3 class = bridge subclass = PCI-PCI mlx4_core0@pci0:129:0:0: class=0x028000 card=0x005115b3 chip=0x100315b3 rev=0x00 hdr=0x00 vendor = 'Mellanox Technologies' device = 'MT27500 Family [ConnectX-3]' class = network none6@pci0:132:0:0: class=0x130000 card=0x148a1022 chip=0x148a1022 rev=0x00 hdr=0x00
Code:
dmesg | grep Mellanox mlx5en: Mellanox Ethernet driver 3.5.1 (April 2019) mlx4_core: Mellanox ConnectX core driver v3.5.1 (April 2019)
This card was set to ETH mode in Windows previously. Maybe I need to set the card to ETH mode in FreeNAS again? I read something about a system tunable to accomplish that (sys.device.mlx4_core0.mlx4_port0 = eth) but I am not sure how to do that and find the right "device path".
Can somebody please assist?
Thanks in advance!
Chris