Hi.
So redoing Freenas server and installing it fresh with 9.3 (FreeNAS-9.3-STABLE-201506292332) via USB.
After install and then the first reboot, I get the this error. (picture attached)
This is what I tried so far:
- Verified ISO is good download via hash.
- Tried multiple USB thumb drives. USB 3.0 and USB 2.0 8gb, 16gb and 32gb. San disk, Kingston, PNY.
- Using only USB 2.0 ports in the back to do the install.
- Tried increasing that delay time (Via here in the forums) and no luck.
- Installed version 9.2.1.9 on the same thumb drives to verify that it's just a version issue. Version 9.2.1.9 installed with no issues. Assuming thumb drivers are good.
This server has 32 Gigs of ECC Ram running on a E3 1246 Xeon processor.
The bios doesn't allow me to disable usb 3.0 but there's an option for legacy mode which I have to keep on in order for my USB keyboard to work. No option regarding XHCI either.
So looking for ideas and thoughts? Kinda out of it.
Thanks in advance.
So redoing Freenas server and installing it fresh with 9.3 (FreeNAS-9.3-STABLE-201506292332) via USB.
After install and then the first reboot, I get the this error. (picture attached)
This is what I tried so far:
- Verified ISO is good download via hash.
- Tried multiple USB thumb drives. USB 3.0 and USB 2.0 8gb, 16gb and 32gb. San disk, Kingston, PNY.
- Using only USB 2.0 ports in the back to do the install.
- Tried increasing that delay time (Via here in the forums) and no luck.
- Installed version 9.2.1.9 on the same thumb drives to verify that it's just a version issue. Version 9.2.1.9 installed with no issues. Assuming thumb drivers are good.
This server has 32 Gigs of ECC Ram running on a E3 1246 Xeon processor.
The bios doesn't allow me to disable usb 3.0 but there's an option for legacy mode which I have to keep on in order for my USB keyboard to work. No option regarding XHCI either.
So looking for ideas and thoughts? Kinda out of it.
Thanks in advance.