petr
Contributor
- Joined
- Jun 13, 2013
- Messages
- 142
Hi,
I have recently upgraded to latest Freenas 11 from 9.3 and everything seems OK, except jails. They start up just fine, however, no IP addresses are assigned.
The settings are still there and correct in jails settings, let's use one as an example. It has IP address set to 192.168.2.106 in the jails settings. When it comes up, ifconfig does not show any IP addresses.
However, networking is fine - because if I go into the jail via jexec, I can issue:
And everything starts working again. Any hints what may be wrong?
ifconfig inside of the jail:
ifconfig after manually issuing the above commands:
I have recently upgraded to latest Freenas 11 from 9.3 and everything seems OK, except jails. They start up just fine, however, no IP addresses are assigned.
The settings are still there and correct in jails settings, let's use one as an example. It has IP address set to 192.168.2.106 in the jails settings. When it comes up, ifconfig does not show any IP addresses.
However, networking is fine - because if I go into the jail via jexec, I can issue:
ifconfig epair11b 192.168.2.106
route add default 192.168.2.3
And everything starts working again. Any hints what may be wrong?
ifconfig inside of the jail:
Code:
root@sickbeard_1:/ # ifconfig lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384 options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6> inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1 inet 127.0.0.1 netmask 0xff000000 nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> epair11b: flags=8842<BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8<VLAN_MTU> ether 02:a3:a3:00:12:0b nd6 options=1<PERFORMNUD> media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>) status: active
ifconfig after manually issuing the above commands:
Code:
root@sickbeard_1:/ # ifconfig lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> metric 0 mtu 16384 options=600003<RXCSUM,TXCSUM,RXCSUM_IPV6,TXCSUM_IPV6> inet6 ::1 prefixlen 128 inet6 fe80::1%lo0 prefixlen 64 scopeid 0x1 inet 127.0.0.1 netmask 0xff000000 nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL> epair11b: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500 options=8<VLAN_MTU> ether 02:a3:a3:00:12:0b inet 192.168.2.106 netmask 0xffffff00 broadcast 192.168.2.255 nd6 options=1<PERFORMNUD> media: Ethernet 10Gbase-T (10Gbase-T <full-duplex>) status: active