Thomas Sjunnesson
Cadet
- Joined
- Jun 30, 2017
- Messages
- 4
Installed a brand new FreeNAS-server for iscsi use.
I have set up an iscsi target, called target1, which I connect to using Windows Server 2016.
It works without any problems at all.
Then, I added target2, target3, target4. None of these are visible in my iSCSI initiatior, even if I rescan the iscsi portal.
All targets (extents) are file-based.
Do I have to reload the iscsi service?
How do I do that, without interrupting the existing connection to target1?
My old non-FreeNAS server used debian.
In that Environment I could add/remove iscsi targets with the ietadm utility.
I am trying to achieve the same functionality with FreeNAS.
All comments/suggestions/ideas are appreciated.
Thank you.
I have set up an iscsi target, called target1, which I connect to using Windows Server 2016.
It works without any problems at all.
Then, I added target2, target3, target4. None of these are visible in my iSCSI initiatior, even if I rescan the iscsi portal.
All targets (extents) are file-based.
Do I have to reload the iscsi service?
How do I do that, without interrupting the existing connection to target1?
My old non-FreeNAS server used debian.
In that Environment I could add/remove iscsi targets with the ietadm utility.
I am trying to achieve the same functionality with FreeNAS.
All comments/suggestions/ideas are appreciated.
Thank you.
Last edited by a moderator: