William Katsak
Dabbler
- Joined
- Apr 22, 2014
- Messages
- 31
Hello,
I just built a brand new box based on a Supermicro A1SAi-2750F. Beautiful board, everything went together nicely except for one thing: I picked up a Innodisk SATADOM for a boot drive (this one to be exact), and the board doesn't see it. I actually bought two, and it sees neither of them. I've tried a couple different power cables, different SATA ports, etc. The cables I am using are getting power from molex. I checked the voltage going to the unit, it is fine. I've even tried it on a different motherboard (old Intel D525MW). No dice.
I would be surprised if two units were defective. Anyone use these units successfully for FreeNAS or anything else?
Thanks,
Bill Katsak
I just built a brand new box based on a Supermicro A1SAi-2750F. Beautiful board, everything went together nicely except for one thing: I picked up a Innodisk SATADOM for a boot drive (this one to be exact), and the board doesn't see it. I actually bought two, and it sees neither of them. I've tried a couple different power cables, different SATA ports, etc. The cables I am using are getting power from molex. I checked the voltage going to the unit, it is fine. I've even tried it on a different motherboard (old Intel D525MW). No dice.
I would be surprised if two units were defective. Anyone use these units successfully for FreeNAS or anything else?
Thanks,
Bill Katsak