diedrichg
Wizard
- Joined
- Dec 4, 2012
- Messages
- 1,319
The backstory:
I upgraded from 11.2-U7 to 11.3-RELEASE. I ran into an issue where I couldn't access the web UI. Navigating the shares and IPMI were no issue. It didn't occur to me to just roll back and attempt GUI access. So I stayed on 11.3 and reverted the database to defaults via IPMI. This then gave me GUI access. (I wasn't too heartbroken because my configs have been upgraded through all the versions ever since about ¿9.1. It was probably a good thing to clear out any gremlins.)
The question:
Anyways, this of course got rid of my SMART, scrub and CRON schedules.
I upgraded from 11.2-U7 to 11.3-RELEASE. I ran into an issue where I couldn't access the web UI. Navigating the shares and IPMI were no issue. It didn't occur to me to just roll back and attempt GUI access. So I stayed on 11.3 and reverted the database to defaults via IPMI. This then gave me GUI access. (I wasn't too heartbroken because my configs have been upgraded through all the versions ever since about ¿9.1. It was probably a good thing to clear out any gremlins.)
The question:
Anyways, this of course got rid of my SMART, scrub and CRON schedules.
- Is there a way to read the config database on a client machine without rolling back to 11.2-U7 and loading the pre-update config?
- If I DO do that, would that cause any latent issues for rolling forward to 11.3 and reloading my new, fresh config?
- FreeNAS 11.3-RELEASE
- Supermicro X10SLM-F-O uATX
- Intel Xeon E3-1270 v3
- Kingston 32GB (8GB x 4) ECC w/Hynix DRAM, 1333MHz, 1.5V - KVR1333D3E9SK2/16G
- (4) WD Red 2TB in RaidZ2
- Boot drive: Supermicro 16GB SATADOM - SSD-DM016-PHI