Had to Rebuild one drive in Raid5, now freenas cant see mount point.

[Onji]

Hello, first time posting here so I hope I have the correct section of the forums.

I had one of my 2tb drives go out, and had to replace and rebuild. Its RAID5 with 4x2tb drives on the Intel Matrix hardware raid (i know).

It took 80+ hours for the rebuild to complete, but as you can see here. Its back online and looks good:
http://i.imgur.com/kabvmRj.jpg

However, within Freenas it shows I have no disks configured under the main system page.
I did check and under disks-management, I can see the raid:
http://i.imgur.com/JHeIask.jpg

But when I check under mount point it shows an error by status:
http://i.imgur.com/IzKxXYR.jpg

I did notice while booting there were a few gpt errors
(i applogize for some of the overlapping of these images, it was tough capturing them with my phone as the screen went by:
http://i.imgur.com/zJv8nL3.jpg
http://i.imgur.com/ase0PMP.jpg
http://i.imgur.com/DCJERaS.jpg

I'm sure my data is still there, but I just need to maybe re-link it somehow? Any assistance would be greatly appreciated. I tried to be as thorough as I could with this post, but if you need any info or want me to run any commands please let me know.
Thank you.

 

[cyberjock]

That is FreeNAS .7. That is not supported in this forum as that is not the software that this forum has ever supported.

Read the forum rules thread specifically for FreeNAS 0.7: http://forums.freenas.org/threads/if-using-freenas-0-7-read-this.740/

I will tell you that if you were running a hardware RAID with ZFS in FreeNAS 8 you'd likely be kissing your data goodbye forever. No clue with .7 though as it was a different project, different developers, different design, etc.

 

[Onji]

Oops. Ok thank you.