narcofreccia
Cadet
- Joined
- Sep 11, 2015
- Messages
- 3
Hi, I had the brilliant idea to update my freenas box to the 9.10.2 through the gui for no good reasons as everything was working spot on and properly configured (cifs, 10g sfp+, syncthing, sabnzb, dronenzb, couchpotato, transmission, sickrage, plex).
After the update was done i was no longer able to access the webgui nor see my shares, plugged a monitor and saw that the ip address for the gui wouldn't show up. Did reset the interface and boom, could see 192.168.1.x again. When i got the gui i saw al my settings and jails running but none of the plugins would switch on, that was easy to fix by just stopping and starting the jail. At this point everything seemed to work just fine again exept for when i reboot or switch the nas off, when i have to start over again...no ip, delete the interface, create the interface..and so on...
Does anyone know how to fix this without a clean install?
After the update was done i was no longer able to access the webgui nor see my shares, plugged a monitor and saw that the ip address for the gui wouldn't show up. Did reset the interface and boom, could see 192.168.1.x again. When i got the gui i saw al my settings and jails running but none of the plugins would switch on, that was easy to fix by just stopping and starting the jail. At this point everything seemed to work just fine again exept for when i reboot or switch the nas off, when i have to start over again...no ip, delete the interface, create the interface..and so on...
Does anyone know how to fix this without a clean install?