Hoeser
Dabbler
- Joined
- Sep 23, 2016
- Messages
- 23
Hi All,
I'm pretty new to using FreeNAS as an iSCSI SAN - I've got a Qlogic card in the box, and it's setup and working, what I find confusing is that when I add a zvol as an extent, my vmware systems pick it up immediately - shouldn't this not show up until I create a target/extent mapping on the next tab?
With this behavior I am unable to specify any LUNid's.
I used to use iSCSI over ethernet and it would never present any devices until the extent mapping was complete.
I'm pretty new to using FreeNAS as an iSCSI SAN - I've got a Qlogic card in the box, and it's setup and working, what I find confusing is that when I add a zvol as an extent, my vmware systems pick it up immediately - shouldn't this not show up until I create a target/extent mapping on the next tab?
With this behavior I am unable to specify any LUNid's.
I used to use iSCSI over ethernet and it would never present any devices until the extent mapping was complete.